Impianto a gas su motore a iniezione

  • 18 Risposte
  • 2959 Visite
Re:Impianto a gas su motore a iniezione
« Risposta #15 il: Maggio 31, 2018, 11:51:06 am »
E' un miscelatore di gas che funziona con un motore passo-passo , e ha bisogno di una elettronica che lo comanda , oltreche' ha bisogno di  prendere segnali da rilevatori che noi non abbiamo . Un ottimo
"aggeggio" ma non credo si possa montare . Il suo scopo e' quello di  miscelare il gas in base al comando accelleratore , tagliandolo addirittura in fase di rilascio . Questo per  rendere superfluo il montaggio di un anello riduttore di aria sul condotto dell'aria . Ricordo che il necessario anello riduttore di aria e' indispensabile  per ottimizzare il rendimento del motore a bassi e medi regimi con il gas , ma e' controproducente con la benzina , perche' "strozzando" l'aria , il motore rendera' di meno ...
« Ultima modifica: Maggio 31, 2018, 11:53:26 am da Citrozeta »

*

Offline hal9000

  • ******
  • 5.270
  • La mia mente sta svanendo... giro giro tondo...
    • DEA da 50 anni
Re:Impianto a gas su motore a iniezione
« Risposta #16 il: Maggio 31, 2018, 12:07:16 pm »
leggendo il manuale, per quel che capisco di inglese, mi sembra che dica che va bene anche per motori a carburatore:



BLOS has been devised to be installed on
injection cars but, thanks to the small vacuum
opening piston, it also fits the carburettor
ones.
On the vehicles provided with a flow meter,
BLOS is installed between the flow meter
and the throttle body. On the vehicles unprovided
with a flow meter, it is installed
between the air filter and the throttle body.

mi sembra che funzioni tipo i carburatori con comando a depressione...

BLOS "normale", perchè c'è anche l'Evolution che mi sa che è quello a cui ti riferisci...
« Ultima modifica: Maggio 31, 2018, 12:12:37 pm da hal9000 »

Re:Impianto a gas su motore a iniezione
« Risposta #17 il: Maggio 31, 2018, 12:24:22 pm »
Mi sa' di si'.......difatti ho scaricato un Pdf ......ed e' dell'evolution

Re:Impianto a gas su motore a iniezione
« Risposta #18 il: Maggio 31, 2018, 01:19:18 pm »
BLOS has been devised to be installed on injection cars but, thanks to the small vacuum opening piston, it also fits the carburettor ones.
On the vehicles provided with a flow meter, BLOS is installed between the flow meter and the throttle body. On the vehicles unprovided
 with a flow meter, it is installed between the air filter and the throttle body.


Ma tanto mica è inglese, è googletranslaterese  ;D
« Ultima modifica: Maggio 31, 2018, 01:21:52 pm da Capitan Uncinema »